Benutzer-Werkzeuge

Webseiten-Werkzeuge


myhobby-cnc:grbl-controller

Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen gezeigt.

Link zu dieser Vergleichsansicht

Both sides previous revision Previous revision
myhobby-cnc:grbl-controller [2019/07/03 13:17]
crix
myhobby-cnc:grbl-controller [2019/07/03 13:19] (aktuell)
crix
Zeile 25: Zeile 25:
  
 **GRBL 0.8c Konfiguration** **GRBL 0.8c Konfiguration**
-{{:myhobby-cnc:grbl-controller-config.jpg |}}+ 
 +<​code>​ 
 +$0=33.333 (x, step/mm) 
 +$1=33.333 (y, step/mm) 
 +$2=320.000 (z, step/mm) 
 +$3=10 (step pulse, usec) 
 +$4=250 (Default feed, mm/min) 
 +$5=500 (Default seek, mm/min) 
 +$6=0 (step port invert mask:00000000) 
 +$7=25 (step idle delay, msec) 
 +$8=25 (acceleration,​ mm/sec^2) 
 +$9=0.010 (junction deviation, mm) 
 +$10=0.002 (arc tolerance, mm) 
 +$11=25 (n-arc correction, int) 
 +$12=3 (n-decimals, int) 
 +$13=0 (report inches, bool) 
 +$14=1 (auto start, bool) 
 +$15=0 (invert step enable, bool) 
 +$16=0 (hard limits, bool) 
 +$17=0 (homing cycle, bool) 
 +$18=0 (homing dir invert mask:​00000000) 
 +$19=25.000 (homing feed, mm/min) 
 +$20=700.000 (homing seek, mm/min) 
 +$21=250 (homing debounce, msec) 
 +$22=1.000 (homing pull-off, mm) 
 +</​code>​
  
 **GRBL 0.9 - 1.1 Konfiguration** **GRBL 0.9 - 1.1 Konfiguration**
 +
 <​code>​ <​code>​
 $0=10 (step pulse, usec) $0=10 (step pulse, usec)
myhobby-cnc/grbl-controller.txt · Zuletzt geändert: 2019/07/03 13:19 von crix

Seiten-Werkzeuge