Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen gezeigt.

--- myhobby-cnc:grbl-controller [2019/07/03 13:17]
crix
+++ myhobby-cnc:grbl-controller [2019/07/03 13:19]
crix
@@ Zeile 25: / Zeile 25: @@
 **GRBL 0.8c Konfiguration**
-{{:myhobby-cnc:grbl-controller-config.jpg |}}
+<code>
+$0=33.333 (x, step/mm)
+$1=33.333 (y, step/mm)
+$2=320.000 (z, step/mm)
+$3=10 (step pulse, usec)
+$4=250 (Default feed, mm/min)
+$5=500 (Default seek, mm/min)
+$6=0 (step port invert mask:00000000)
+$7=25 (step idle delay, msec)
+$8=25 (acceleration, mm/sec^2)
+$9=0.010 (junction deviation, mm)
+$10=0.002 (arc tolerance, mm)
+$11=25 (n-arc correction, int)
+$12=3 (n-decimals, int)
+$13=0 (report inches, bool)
+$14=1 (auto start, bool)
+$15=0 (invert step enable, bool)
+$16=0 (hard limits, bool)
+$17=0 (homing cycle, bool)
+$18=0 (homing dir invert mask:00000000)
+$19=25.000 (homing feed, mm/min)
+$20=700.000 (homing seek, mm/min)
+$21=250 (homing debounce, msec)
+$22=1.000 (homing pull-off, mm)
+</code>
 **GRBL 0.9 - 1.1 Konfiguration**
 <code>
 $0=10 (step pulse, usec)

Wiki